SummaSign Pro T-series Cutters
User’s Manual
Contour Cutting
5.9
♦
Fill in the values for the marker distances and press OK:
5.7
REGISTRATING THE CROSS-MARKS
•
Before proceeding, make sure all the cutting parameters are correct
(pressure, velocity, …). See User’s Manual.
•
Press the
key until the message 'SPECIAL LOAD' is displayed on the
LCD.
SPECIAL LOAD
↵
•
Press the
key.
DIGITIZE ORIGIN
X = 0 Y = 0
↵
•
Position the knife tip exactly above the origin-marker using the
,
,
,
jogging keys.
During this entire procedure, make sure that the knife does not rotate, which
may cause an offset error.
Indicate the cross-marks with extreme accuracy because it directly
influences the result.
Summary of Contents for T1010 Pro
Page 1: ......
