SummaSign Pro T-series Cutters
User’ s Manual
General Information
1-6
1.2.3. KNIVES BALLPOINT PEN AND POUNCING TOOL
The SummaSign Pro cutters are supplied with two standard knives (for vinyl
media), one masking stencil knife, one drag knife and one black ballpoint pen.
Tangential Knife
Medium
Quantity
supplied
Standard knife
(requires a standard knife holder along
with a standard
grey
nose piece)
standard, reflective &
fluorescent vinyl types
2 off
2 off
Double tip knife for high-density
reflective materials
(requires a standard knife holder)
high-density reflective
vinyl types
optional
Knife for masking stencils
(requires a standard knife holder along
with
black
nose piece)
masking stencils &
thick materials
1 off
1 off
1 off
Drag Knife
Standard drag knife
(requires a drag knife holder)
standard, reflective &
fluorescent vinyl types
1 off
1 off
Pen
Colour
Quantity
Ballpoint pen
(requires a ballpoint pen holder)
black
1 off
1 off
Pouncing Tool
Paper
optional
TABLE 1-3 :
SUMMASIGN PRO T-SERIES KNIVES, PENS AND POUNCING TOOLS
To order replacement knives, pens and/or pouncing tools, contact your local
dealer, quoting the part numbers listed in table 1-9. The SummaSign Pro cutters
will only perform according to specifications if a Summagraphics genuine knife,
pen is installed. Do not replace the standard knife, pen or pouncing tool with
products from other manufacturers.
1.2.4. INTERFACE
Communication
standard asynchronous RS-232-C and
Centronics parallel interface
Serial : I/O Port connector
DB-9P
Mating connector
DB-9S
Byte format
8 data bits, 2 stop bits, no parity
Baud rate
38400, 19200, 9600, 4800, 2400 bps
Parallel : I/O Port connector
Centronics female
Mating connector
Centronics male
TABLE 1-4 :
SUMMASIGN PRO T-SERIES INTERFACE SPECIFICATIONS
Summary of Contents for T1010 Pro
Page 1: ......
