S One
User’s Manual
Introduction
1-8
WARNING:
Make sure the power switch is turned off before connecting the power
cord (the “0” side of the ON/OFF rocker switch should be pressed)
.
WARNING:
Do not use the power cord if it is visibly damaged. Disconnect the
power cord by pulling the
plug
, not the
cable
.
WARNING: Keep fingers and other body parts away
from the cutting area. There
are
hazardous moving parts
.
1.
Plug the female end of the AC power cord into the receptacle, located in the power entry
module on the cutter’s rear panel.
2.
Plug the male end of the AC power cord into a properly grounded wall socket.
3.
Power on the cutter by pressing the “I” side of the ON/OFF rocker
switch, located on the
power entry module on the rear panel.
4.
The touchscreen will activate, and the initialization process will begin. If media is loaded,
then the cutter will check the size and load the media.
FIG 1-4
1-4
MEDIA IS LOADED AND THE CUTTER IS READY
FIG 1-5
1-5
CUTTER IS READY AND NO MEDIA IS LOADED
S1D160
50000 x 145 mm
Knife
700 mm/s
90 g
Configuration 1
LAN 192.168.10.2
S1D160
Insert media and lower the
pinch rollers.
Configuration 1
LAN 192.168.10.2
1.3
Powering-on the cutter
