L3214 Laser Cutter
User’s Manual
Maintenance
47
4.1.4
Conveyor planks
To ensure proper fume extraction and vacuum for material transportation, the conveyor planks
need to be free of dust and lint.
1.
Open the safety cover lid and visually inspect the conveyor planks for cleanness and
damage.
2.
Remove large pieces of material by hand, then vacuum the planks.
3.
Close the safety cover lid and feed the conveyor until an uncleaned set of planks is
accessible.
4.
Repeat all the above steps until all planks are clean.
4.1.5
Water-cooled laser unit
The water-cooled laser unit has been designed to be low maintenance. Internal routine
maintenance procedures are not required. The system's sealed construction and limited
number of moving parts ensure trouble-free and reliable operation.
1.
Open the left cover using the cross key to gain access to the laser unit.
2.
The external surfaces of the system can be cleaned with a mild detergent. It is advisable to
use a damp cloth to facilitate the cleaning of the external cabinets.
WARNING
: Take care not to allow entry of water into any of the electrical
cabinets or onto the output window or primary beam delivery optic.
