Sulzer Metco ECO ARC 600, Manual

Page: 50 / 94

ECO ARC 600
5-4
Revision 1/10/08
5.2 Setting-up system
5.2.1 Introducing spray wire
• Put wire spool on its decoiling device.
The wire must run off the spool from the top.
Tighten spring breaks slightly so the spool is not running.
Alternatively:
Guide wire from drums over the deflection rollers.
• Clip off wire tips, round them of with a file and straighten them.
• Insert wire through the wire guide tubes up against the push drive.
• Keep wire pressure levers (11) pushed successively and guide
wire between the pressure rolls through the push drive approx.
200 mm into the hose package.
• Make sure the wire is positioned in the correct groove.
5.2.2 Changing spray wire
• Clip off wire in front of push drive and spray the rest of the wire.
Pull out rest of wire from the contact nozzles with a nipper.
• A new/different wire can be installed as discribed before.