Sullivan-Palatek 125G, Operating And Parts Manual

Page: 9 / 66

SULLIVAN-PALATEK______________________________
9
SECTION 2 - SPECIFICATIONS
MODEL 125G 150G 200G 250G
MOTOR SIZE (HP) 125 150 200 250
AIR DELIVER (CFM) 600 715 1000 1000
MAX. FULL LOAD PRESSURE 125 125 125 150
MIN. FULL LOAD PRESSURE 70 70 70 70
LUBRICOOLANT CAP GAL.
SYS/TANK
33/25 33/25 33/25 33/25
DIMENSIONS: OPEN ENCLOSED
OPEN LENGTH 96 96
WIDTH 58 58
HEIGHT 66 3/8 67
NOTE: SEE INSTALLATION DRAWINGS ON PAGES 57-61 OF THIS MANUAL
2.1 DATA AND DIMENSIONS
SULLIVAN-PALATEK reserves the right to change the design or construction of the
above compressors, or to offer them with options which will cause subject equipment to
differ from the above specifications, without reference to any descriptions in this manual.
2.2 LUBRICATION GUIDE
SULLIVAN-PALATEK recommends using Palasyn 45 synthetic lubricoolant for normal
plant-air service. For compressors running two or three shift operations, extended life
lubricants such as Pallube 32p, or Pal-Extra 44 are offered as factory fill. Also, where
incidental food contact may happen, we offer a Food Grade 32FLL.
For extreme environments (i.e. fine particulate, caustic, acidic, or oxidant atmospheres)
contact the factory for lubricant recommendations. Also, for such conditions we would
suggest oil analysis every 1000 hours.
Mixing of these or any other type of oil or synthetic fluid will void the 5-year compressor
unit warranty and could result in greatly increased maintenance and service expenses.
2.3 APPLICATION GUIDE
Ambient Temperature Range: +35° to +104° F (+1° to +40° C). The lower temperature
limit is to prevent freeze-up of condensate in the aftercooler and/or control lines. When
operating these compressors for plant air in food or beverage processing industries,
contact the factory for a Lubricoolant that is FDA approved for “incidental contact with
foodstuffs." For instrument-grade air, contact the factory for recommendations related to
specialized compressed air preparation accessories.
Whenever a SULLIVAN-PALATEK rotary screw compressor is installed in parallel with a
reciprocating type of compressor, it is imperative that the SULLIVAN-PALATEK be the
“lead” machine and the reciprocating the “lag” machine. That is, the SULLIVAN-
PALATEK should be the first to start and the last to stop when being operated in the
“automatic stop/start” mode, or the first to load and the last to unload, when in the
“continuous run” mode. It should require the least electrical power consumption for the
combination. Maximum number of starts per hour:
Motor HP 125 150 200 250
Starts/Hr 4 4 4 4