Sullair LS-10 18KW 24KT, Operators Manual And Parts Lists

Page: 51 / 90

Section 8
ILLUSTRATIONS AND PARTS LIST
45
8.1 PROCEDURE FOR ORDERING PARTS
Parts should be ordered from the nearest Sullair Representative or the Representative from whom the com-
pressor was purchased. If for any reason parts cannot be obtained in this manner, contact the factory directly
at the addresses, phone or fax numbers listed below.
When ordering parts always indicate the
Serial Number of the compressor. This can be obtained from the Bill
of Lading for the compressor or from the Serial Number Plate located on the compressor.
SULLAIR CORPORATION
Subsidiary of Sundstrand Corporation
3700 East Michigan Boulevard
Michigan City, Indiana 46360 U.S.A.
Telephone: 1--219--879--5451
Fax: (219) 874--1273
Fax: (219) 874--1835 (Parts)
Fax: (219) 874--1288 (Service)
SULLAIR ASIA, LTD.
Sullair Road, No. 1
Chiwan, Shekou
Shenzhen, Guangdong PRV.
PRC POST CODE 518068
Telephone: 755--6851686
Fax: 755--6853473
SULLAIR EUROPE, S.A.
Zone Des Granges BP 82
42602 Montbrison Cedex, France
Telephone: 33--477968470
Fax: 33--477968499
8.2 RECOMMENDED SPARE PARTS LIST
DESCRIPTION KIT NUMBER QTY
element, compressor fluid filter 02250096---783
250025--525 1
element, heavy duty air filter 02250107---327 (25---30HP/ 19---22KW)
043334 1
element, heavy duty air filter 040595 (40HP/ 30 KW) 040596 1
element, primary replacement for separator 250034---113
250034--114 1
kit, repair for air inlet valve 02250088---348
250019--451 1
kit, repair springs for air inlet valve 02250088---348 250029--315 1
kit, repair for minimum pressure/check valve 02250097---609
250026--758 1
kit, repair cap for minimum pressure/check valve 02250097---609 02250046--397 1
kit, repair o---ring for minimum pressure/check valve 02250097---609 02250048--362 1
kit, repair piston for minimum pressure/check valve 02250097---609 02250051--338 1
kit, repair thermal valve 02250096---738 (170 ˚ F) 250025--621 1
kit, repair thermal valve 02250103---509 (190 ˚ F) 02250103--562 1
kit, repair for pressure regulator 250017---280 250019--453 1
kit, repair for blowdown valve 250025---655 250031--772 1
kit, repair for solenoid valve 250038---674 (<= 140 psi/ 9.7 bar) 250038--673 1
kit, replacement for solenoid valve coil 250038---674 (<= 140 psi/ 9.7 bar) 250031--738 1
kit, repair for solenoid valve 250038---675 (>140 psi/ 9.7 bar) 02250055--939 1
kit, replacement for solenoid valve coil 250038---675 (>140 psi/ 9.7 bar) 250038--730 1
kit, repair inlet valve 02250088---348 250019--451 1
kit, repair for v---type strainer 241771
241772 1
kit, repair for shaft seal 001836--007 1
element, replacement for combination separator/trap 02250078---841
02250081--108 1
kit, repair automatic drain for combination separator/trap 02250078---841
02250087--422 1
manual, Sequencing & Protocol
(I)
02250057--696 1
fluid, SRF 1/4000 (5 gallons) 250019--662
(II)
lubricant, Sullube 32 (std.) (5 gallons) 250022--669
(II)
lubricant, 24 KT (5 gallons) 046850--001
(II)
(I)
This document is required to program your personal computer to communicate with the Supervisor
II
panel.
(II) For proper amount of fluid fill, please consult Lubrication Guide in Section 3, Specifications.
PLEASE NOTE: WHEN ORDERING PARTS, ALWAYS INDICATE SERIAL NUMBER OF COMPRESSOR