（
7/24
）
EFP-LC TypeE Supplementary manual
(For RX66T)
7
Command descriptions for RX66T series
Explain the command for dedicated of the RX66T series.
7.1
MCU set command
Command by which target MCU is specified
Format :
t=x
t=xx ; x disregard the effective following from the head to 2 digi ts.
XX: 38 and 39 are effective. The first two digits are valid and the rest are ignored.
38: RX (little endian)
39: RX (big endian)
Description example :
T = 38; Specify RX little endian as the target MCU
Detail:
Target MCU according to compatible products is designated.
Please describe this command on the top of PBT file.
7.2
VDD supply command
Format
: x=1
Description example :
x=1 ; Vdd is supplied to MCU
Detail:
1. VDD(+5V) is supplied to target MCU and access including data read, verificati on, writing in, etc. is enabled.
2. In case power is not supplied to target MCU and VDD supply command is not included in script, an error occurs.
Note:
: Only + 5V can output VDD from EFP-LC.
If the power supply voltage exceeds the absolute maximum rating of the MCU, the MCU may be damaged. Please
use it after confirming enough.
: Current capacity that can be provided is up to about 300mA. Nonetheless in case incoming current of substrate is too
much, an error occurs, and in the worst case EFP -LC itself is reset. In case this command is used, please do so, taking
account of consumption current of target substrate.
: Please describe this command after MCU set command.