（
13/24
）
EFP-LC TypeE Supplementary manual
(For RX66T)
7.7
Blank check command
Format:
B,[Start address],[End address]
* Start address : Start address of the area to be Blank check.
* End address : End address of the area to be Blank check.
Description example:
B,FFFFF000,FFFFFFFF
Detail:
Checks that the MCU built-in ROM within the specified range has been erased.
Note:
* In the RX66T series, execution units differ between the code flash area and data flash area. Specify the start address
and end address as shown in the table below.
Table7.4
Start / End Address
Memory area
Execution unit
[Byte]
Start address
End address
Code flash
256
xxxxxx00h
xxxxxxFFh
Data flash
16
xxxxxxx0h
xxxxxxxFh
* A blank error will occur if the area is set to TM (trusted memory).