Suez Sievers UPW Boron Analyzer, Operation And Maintenance Manual

Page: 57 / 104

SUEZ © 2018 57 of 104 DLM 71000-03 EN
Rev. B
Chapter 5: System Configuration
3. Highlight ANALYSIS and press ENTER ; this displays ANALYSIS in the upper-left portion of the
screen and returns the Analyzer to the Setup menu.
4. Press EXIT to return to the Main Menu .
• The other four modes ( CELL SLOPE CAL, CELL OFFSET CAL, CALIBRATION , and
VERIFICATION ) should only be accessed by Technical Support or your local service provider
during calibration/verification.
INSTRUMENT LOCATION
The INSTRUMENT LOCATION is a user-configurable text description used to identify the Analyzer
location in the facility. To set the Analyzer location:
1. Press SETUP from the Main Menu .
2. Highlight INSTR LOCATION and press ENTER . There are fourteen spaces available. The first
space is highlighted to indicate that the instrument location can be edited. The spaces may be
filled with a letter, digits 0-9, or a blank.
3. Use the UP and DOWN arrow keys to scroll through the letters, numbers, and the blank.
4. Move the cursor to the next space by pressing the RIGHT arrow key.
5. When the instrument location has been set, press ENTER to save the instrument location and
return to the Setup menu.
6. Press EXIT to return to the Main Menu .
CLOCK
1. To set the Analyzer's clock, press SETUP from the Main Menu .
2. Highlight CLOCK and press ENTER . This allows the day, month, year, and time to be edited.
These parameters must be set accurately to determine correct timing of measurements, trends,
messages, and data collection activities.
3. Use the arrow keys to highlight the desired value. Press the horizontal arrow to move to the next
time setting.
4. When all the time settings have been set, press ENTER to save the settings and return to the
Setup menu.
5. Press EXIT to return to the Main Menu .
Note:
Pressing
EXIT
instead of
ENTER
will exit the clock editing menu without saving any
changes.