CheckPoint Pharma and CheckPoint
e
Operation and Maintenance Manual
SUEZ © 2018
62 of 112
DLM 97200-03 EN Rev. A
Grab Sample Mode
You can run the Analyzer in
Grab Sample
mode when you need to analyze sample in a bottle (or, if
you have purchased the optional Calibration kit, in a vial). To enter
Grab Sample
mode, access the
Main
screen, press
F1
, and then press
F2
. Make sure the sample inlet line is configured to draw
sample from a vial or bottle before pressing
F1
to start analysis. If needed, press
F4
to stop analysis.
If a printer has been installed, the CheckPoint will print the results of the grab measurement upon
completion.
System Constants
From the
Mode
screen, select
View Constants
to view the current Sensor constants; select
Restore
Constants
to load constants into the Sensor from a file saved to a USB flash memory drive. You can
also import the system constants information into a spreadsheet program for reference, as described
in
”Appendix B: Importing Sensor Data into a Spreadsheet Program.”
I/O Menu Options
When configured with the I/O option, the CheckPoint provides a variety of data output options.
Access the
I/O
menu by pressing
F2
from the
Main
screen.
Analog Outputs
The CheckPoint provides three analog outputs, which can be configured as follows.
N
OTE
: This menu option does not appear if the additional I/O features are not installed in your
configuration.
Instruments built prior to release 1.04 may have only two analog outputs. The available outputs
otherwise operate the same.
1. Scroll to Analog Outputs and press
.
2. Press
F1
to configure
Analog output 1,
press
F2
to configure
Analog output 2
, or press
F3
to configure
Analog output 3
. (These menu options are not displayed if the Sensor has not
been configured with I/O features.)
3. Pressing the
Function
button enters the selected channel’s
Setup
screen. Use the
Vertical
Scroll
bar to highlight an option, and then press the
button to select that option.
