Page 34
Component Removal
Warming Drawer WWD30-2
4-11
#814750 - Revision A - January, 2011
FAN
Remove nut
Disconnect from
power board
Power Cord Removal
NOTE
:
See all Warnings and Cautions at beginning of
Section.
1. Disconnect Electrical Supply to Unit.
2. Stainless steel drawer box must be removed from
drawer.
3. Remove drawer from unit. (
Page 4-3
)
4. Lift center slide assembly out of unit and set aside.
5. Remove (4) screws from fan baffle plate and set plate
aside for reassembly. (
See Figure 4-16
)
6. Disconnect wires from power board being lead.
(
See Figure 4-35
)
7. Remove the large nut securing the power cord strain
relief to the unit. (
See Figure 4-35
)
8. Remove the power cord from the unit.
Metal edges may be sharp. Use caution when
servicing unit to avoid personal injury.
ELECTRICAL SHOCK HAZARD - DISCONNECT
ELECTRICAL SUPPLY TO UNIT BEFORE ATTEMPT-
ING THE FOLLOWING PROCEDURES.
Figure 4-35. Power Cord Removal
