Black plate (233,1)
一
般
Model "A1270GE-A" EDITED: 2016/ 3/ 10
&
Daytime running light system
(if equipped)
WARNING
The light switch must always be
turned to the
“ ”
position when it
is dark outside.
The daytime running light will automati-
cally illuminate at reduced brightness
when the following conditions are fulfilled.
.
The engine is running.
.
The light control switch is in the
“
AUTO
”
(if equipped) or off position.
NOTE
.
If the parking brake is applied when
you start the engine, the daytime run-
ning light will illuminate when the
parking brake is released.
.
When the headlight switch is in the
“
”
or
“ ”
position, the daytime
running light system is deactivated.
.
For models with the auto on/off
headlights, while the headlight switch
is in the
“
AUTO
”
position and the
headlights turn on automatically, the
daytime running light is deactivated.
Turn signal lever
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by hand.
To signal a lane change, push the turn
signal lever up or down slightly and hold it
during the lane change. The turn signal
indicator lights will flash in the direction of
the turn or lane change. The lever will
return automatically to the neutral position
when you release it.
NOTE
For models with a turn signal lever on
the right side of the steering wheel, the
pushing direction of the turn signal
lever is the opposite of that described
here.
&
One-touch lane changer
To flash the turn signal and turn signal
indicator light three times, push the turn
signal lever up or down slightly and
immediately release it.
The operational/non-operational setting of
the one-touch lane changer
’
s can be
changed by a SUBARU dealer. We
recommend that you contact the nearest
SUBARU dealer for details.
Instruments and controls/Turn signal lever
3-99
3
