Black plate (229,1)
一
般
Model "A1270GE-A" EDITED: 2016/ 3/ 10
&
High/low beam change
(dimmer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light
“
”
on the combina-
tion meter is also on.
To switch back to low beam, pull the lever
back to the center position.
&
High Beam Assist function (if
equipped)
NOTE
.
Do not overestimate the capacity of
the High Beam Assist function. The
driver always has the responsibility to
understand the surrounding situation,
to drive safely, and to change the
headlight mode manually if necessary.
.
Observe the following points in
order to operate the High Beam Assist
function properly.
–
Do not attach labels or stickers to
the windshield glass near the cam-
era.
–
Do not attach any accessories
near the inside mirror and camera.
–
Do not place any objects over the
dashboard.
–
Do not touch the lens of the
camera.
–
Do not touch the camera.
–
Do not apply any strong impact
to the camera or the inside mirror.
–
Do not disassemble the camera
and inside mirror.
–
Do not spill liquid on the inside
mirror and camera.
–
Do not carry excessive luggage.
–
Do not modify the vehicle.
–
Always replace the windshield
glass with genuine SUBARU parts
(or equivalent products).
1)
Camera for High Beam Assist function
The high beam assist function automati-
cally changes the headlight from high
beam to low beam (or vice versa). When
all of the following conditions are met, the
headlight will change to high beam.
.
When the vehicle speed increases to
or above the preset level.
.
There is no preceding vehicle.
.
The forward area of the vehicle is dark.
When any of the following conditions is
Instruments and controls/Light control switch
3-95
–
CONTINUED
–
3
