Subaru Legacy 2021, Owner'S Manual

Page: 349 / 592

(345,1)
北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
& Alternate Operation Method
for Models with “Keyless Ac-
cess with Push-Button Start
System”
Access key fob
1) Lock button
An access key fob can be used as the
remote engine start transmitter. Operate
the lock button to start or stop the engine
as follows.
!
Before starting the engine
Before using the remote engine start
system to start the engine, confirm the
following conditions.
. The select lever is in the “P” position.
. All doors including the rear gate are
closed.
. The engine hood is closed.
. The push-button ignition switch is in the
“OFF” position.
! Starting the engine
To start the engine with remote engine
start system, briefly press the lock button
twice within 2 seconds, then press and
hold the lock button for 3 seconds.
1. Press the lock button briefly. The
hazard warning flashers then flash once
and the keyless buzzer chirps once.
2. Within 2 seconds, press the lock button
briefly again. The hazard warning flashers
then flash once again, and the keyless
buzzer chirps once again.
3. After step 2, immediately press and
hold the lock button. The hazard warning
flashers then flash three times, and the
horn will honk once.
4. Approximately 3 seconds after step 3,
release the lock button. The engine will
then start successfully.
! Stopping the engine
Press and hold the lock button to stop the
engine with remote engine start system.
!
Remote start safety features
For detailed information, refer to “Remote
start safety features”
F
P340.
& Entering the Vehicle While It
Is Running via Remote Start
(Models without “Keyless
Access with Push-Button
Start System”)
1. Unlock the vehicle doors using the
remote keyless entry system.
NOTE
If the vehicle’s doors are unlocked
manually using the key, the vehicle’s
alarm system will trigger (if the alarm
system is armed prior to activating the
remote engine start system) and the
engine will turn off. Perform either of
the following procedures to disarm the
alarm system. Refer to “Alarm System”
F
P141.
– Insert the key into the ignition
switch and turn it to the “ON”
position.
– Press any button on the remote
keyless entry transmitter.
2. Enter the vehicle. The engine will shut
down when any door or rear gate is
opened.
3. Insert the key into the ignition switch
and turn it to the “START” position to
restart the engine.
– CONTINUED –
Remote Engine Start System (Dealer Option)
343
7
Starting
and
Operating