Subaru Impreza 2003, Service Manual

Page: 1574 / 3610

4AT-42
AUTOMATIC TRANSMISSION
AUTOMATIC TRANSMISSION ASSEMBLY
B: INSTALLATION
1) Install the rear cushion rubber to transmission
assembly.
Tightening torque:
39 N·m (4.0 kgf-m, 29 ft-lb)
2) Install the ST to torque converter clutch case.
ST
498277200 STOPPER SET
3) Install the transmission onto engine.
(1) Gradually raise the transmission with trans-
mission jack.
(2) Engage them at splines.
4) Install the transmission rear crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51 ft-lb)
5) Take off the transmission jack.
6) Tighten the nuts and bolts which hold the lower
side of transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
7) Lower the vehicle.
8) Connect the engine and transmission.
(1) Remove the ST from torque converter clutch
case.
NOTE:
Be careful not to drop the ST into torque converter
clutch case when removing ST.
ST
498277200 STOPPER SET
(2) Install the starter.
<Ref. to SC(H4SO)-7, INSTALLATION, Start-
er.>
(3) Tighten the bolt which holds the right upper
side of transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
AT-00103
ST
AT-00109
AT-00026
T 2
T 2
T 1
AT-00108
AT-00106