Black plate (200,1)
一
般
Model "A2510GE-B" EDITED: 2015/ 6/ 25
3-50
Instruments and controls/Turn signal lever
&
Headlight flasher
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will remain on for as long as you
hold the lever. The headlight flasher works
even though the light switch is in the off
position.
When the headlights are on high beam,
the high beam indicator light
“
”
on the
combination meter also illuminates.
&
Daytime running light system
(if equipped)
WARNING
The light switch must always be
turned to the
“ ”
position when it
is dark outside.
The daytime running light will automati-
cally illuminate at reduced brightness
when the following conditions are fulfilled.
.
The engine is running.
.
The light control switch is in the
“
AUTO
”
(if equipped) or off position.
NOTE
.
If the parking brake is applied when
you start the engine, the daytime run-
ning light will illuminate when the
parking brake is released.
.
When the headlight switch is in the
“
”
or
“ ”
position, the daytime
running light system is deactivated.
.
For models with the auto on/off
headlights, while the headlight switch
is in the
“
AUTO
”
position and the
headlights turn on automatically, the
daytime running light is deactivated.
Turn signal lever
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by hand.
To signal a lane change, push the turn
signal lever up or down slightly and hold it
during the lane change. The turn signal
indicator lights will flash in the direction of
the turn or lane change. The lever will
return automatically to the neutral position
when you release it.
