2 Operating Instructions: DTP05(-Ex)
Section I
–
Correct Use and Application
General
The unit described in the present operating instructions must be used, operated and
serviced in accordance with the present instructions. Any other type of use is beyond
the scope of application and can result in damage or injury to personnel, the unit or
property. The unit described in the present operating instructions complies with BS EN ISO
17050-1:2010 and the EC Machinery Directive 2006/42/EC.
Foreseeable Misuse of the Unit
Personnel must take care when operating the unit. The following actions must be
adhered to:
•
The maximum safe working load (SWL) must not be exceeded.
•
Do not travel with a raised load 500mm above the ground unless necessary.
•
When manoeuvring the unit, do not exceed a speed of 1m/s (3.6km/h).
•
When manoeuvring a raised load above 500mm, do not exceed a speed of
0.1m/s (0.36km/h).
•
If applicable, do not over lower the head of the unit onto a platform, such as
a mezzanine floor.
•
Do not carry or lift other personnel.
•
Do not stand or ride on the unit.
•
Loads must be undamaged.
•
Do not negotiate inclines unless otherwise stated.
•
Do not stand underneath a raised load or within the confines of the unit
during operation.
•
The load must be lifted and/or mixed by the attachment provided.
•
Do not alter the unit specification from original supply.
•
Do not disable, remove or adjust safety mechanisms or switches.
•
Observe all instruction decals applied to the unit.
•
Do not leave the unit in direct sunlight.
•
The manufacturer shall not be held liable in case of faults or accidents due to
negligence, incapacity, installation by unqualified personnel or improper use.
Approved Application Conditions
•
Operation in dry industrial and commercial environments.
•
Permissible temperature range 5°C to 40°C.
•
Lighting of at least 300 Lux.
•
Altitudes not exceeding 2000m.
•
Operation only on secure, level surfaces with sufficient capacity.
•
Operation only on routes that are visible and approved by the proprietor.
•
Operation in accordance with guidance stated within the operating
instructions.
•
The unit must be maintained in accordance with the maintenance schedule
stated within the operating instructions.
•
Appropriate personal protective equipment, PPE, must be worn at all times.
