Stryker SwitchPoint Infinity 2, Operation And Maintenance Manual, Page: 46 / 82

44
12.6.2 View Only
A “View Only” call is initiated from the “Manual Dial” interface or can be stored as a preset and initiated from the
“Call Groups” interface.
To create a View Only call:
1. Navigate to the Manual Dial interface and select “View Only” from the “Connection Type” drop down
menu.
2. Select the endpoint that is broadcasting from the “Room Name” drop down menu.
3. Press the green Call button to initiate the “View Only” call.
An endpoint can only view one broadcast call at a time.
To disconnect from a “View Only” call, press the red Hang Up button below the keypad on the “Active Call”
interface.
12.6.3 Meeting Room
The “Meeting Room” call feature is only available on an ORIS equipped with a Video Network Hub™ that has the
Meeting Room option installed. If these features are available within the ORIS, the SwitchPoint Infinity® 2 Control
System is automatically capable of using them, and no additional configuration is necessary.
A “Meeting Room” call is any call that consists of more than two endpoints exchanging two-way audio and video.
The Meeting Room call feature supports a maximum of four (4) endpoints. It is capable of using the Codec within
the Video Network Hub™ as one endpoint, allowing up to three local and one “remote” endpoint to participate in
a Meeting Room call.
A “Meeting Room” call is initiated from the “Manual Dial” interface or can be stored as a preset and initiated from
the “Call Groups” interface.
To create a Meeting Room call:
1. Navigate to the “Manual Dial” interface and select “Room” from the “Connection Type” drop down menu.
2. Select the first endpoint that is participating in the Meeting Room call.
3. Press the green Call button to initiate the call.
4. Navigate to the “Manual Dial” interface and repeat the above steps until all desired endpoints are
connected to the Meeting Room call.
A Codec can be added to the Meeting Room call by selecting a Codec Call type from the “Connection Type” drop
down menu and dialing a Codec call. For information on dialing Codec calls, please see the “Offsite (Codec)
Calls” section in this manual.
A Meeting Room call can be disconnected by pressing the red Hang Up button from the “Active Call” interface.
Note
All endpoints must disconnect from a Meeting Room call individually. Disconnecting only the
call originator does not end the call.
StockCheck.com