Stryker SwitchPoint Infinity 2, Operation And Maintenance Manual, Page: 44 / 82

42
4. Enter the ISDN phone number using the on-screen keypad (no dashes required).
5. Press the green Call button to initiate the call.
or
6. Press the Store Number button to store call information to “Call Groups” presets.
12.5.2 Making a Codec Gateway Call
Note
A gateway call is only used if the environment contains a specialized H.320/H.323 gateway device.
Check with your local IT department for information on using this device, as it may require
custom configuration and dialing strings.
To dial a Hub Codec Gateway or Local Codec Gateway call:
1. Select the call type from the “Connection Type” drop down menu.
2. Select the Codec to be used from the “Codec Name” drop down menu.
3. Select the call “speed” or bandwidth from the “Connection Speed” drop down menu.
4. Enter the gateway prefix (if required) and phone number using the on-screen keypad (no dashes
required).
5. Press the green Call button to initiate the call.
or
6. Press the Store Number button to store the call information to “Call Groups” presets.
12.5.3 Wait for Offsite Call
The SwitchPoint Infinity® 2 Control System can wait for an incoming Codec call from a specific Codec connected
to the system.
To wait for a specific incoming Codec call:
1. Select the “Calls” tab on the Menu Bar.
2. Select the “Manual Dial” tab.
3. Press the Wait for Offsite Call button below the drop down menu.
4. A pop-up window will appear. Select which Codec to wait for from the drop down menu.
StockCheck.com