Stryker Power-PRO XT, Maintenance Manual

Page: 54 / 186

A
B
C
D
E
F
F Fiig gu urre e 2 25 5 –– R Ra attcch he ett a asssse em mb bllyy rre ep plla acce em me en ntt ((X XP PS S))
6. Grasp the ratchet assembly and pull it toward the head end of the cot to remove.
7. Reverse steps to reinstall.
8. Verify proper operation before you return the product to service.
R Re elle ea asse e h ha an nd dlle e a asssse em mb bllyy rre ep plla acce em me en ntt ((X XP PS S o op pttiio on n))
T To oo ollss rre eq qu uiirre ed d::
• 3/32'' hex wrench
• Small slotted screwdriver
P Prro occe ed du urre e::
1. Raise the product to the highest height position.
2. Raise the siderail to the up and locked position.
3. Using a 3/32" hex wrench, remove the four screws (A) that secure the release cover (B) to the overmold assembly to
remove the release cover (Figure 26).
4. Using a small slotted screwdriver, pry the release handle return spring (C) up to remove the spring (Figure 26).
5. Grasp the release handle assembly (D), and hinge it upward on the spring side to remove it from the cover (Figure 26).
EN 48 6506-109-002 Rev G.1