Stryker Power-PRO XT 6500, Operation And Maintenance Manual

Page: 22 / 172

22 6500-509-001 REV B www.stryker.com
Return To Table of Contents
Product Inspection
The condition of the cot is the responsibility of the owner. It is important that the cot is working properly before the
product is put into service. Have a qualified service technician use the following list and the operation instructions to
check the cot before the product is put into service.
The battery must be charged prior to checking the features and condition of the cot.
Item Routine
Battery Unpack batteries and charger
Charge battery according to SMRT Power System instructions (6500-009-101) or DeWALT
®
Battery System instructions
The power indicator LED, located at the foot end control enclosure of the cot, is solid green when the battery is fully
charged or has adequately charged battery power.
CAUTION
When charging a battery in an ambulance, locate the charger in an enclosed cabinet and out of patient reach during
transport.
After the battery is fully charged, inspect the cot for the following points:
Item Routine Page
Battery Charge spare battery (if necessary) according to SMRT Pak or DeWALT
®
battery instructions
Install battery into foot end enclosure - power indicator LED operates
44
Ensure that the battery remains firmly secured 44
Release and remove battery from foot end enclosure 44
Reinstall battery into foot end enclosure 44
Hydraulics Inspect motor mount - all fasteners secure 75
Check cylinder attachments at both ends - all fasteners secure 75
Inspect main cable - all connections secure 75
Inspect hoses and cylinder seal for leaks 75
Electronic
Controls Check power indicator LED - charged 46
Extend cot to raised position 33
Verify ”jog” function operates smoothly 33
Lower to retracted position - cot secures in a mid-height position
(motor does not operate)
33
Determine and set ambulance vehicle load height 21
Check high speed retract 35
Extend cot to full height - no drift 33
Manual Back-up
Release Verify the manual back-up release handle functions properly - adjust
accordingly 39
With the cot empty, check the raise/lower function 39
With the cot loaded with a minimum of 99 pounds (45 kg), check the raise/
lower function 39
With the cot loaded with a minimum of 99 pounds (45 kg), check the load/
unload function 39