1-68
28EX-009-002 REV B
En
gli
sh
BED CASTER REPLACEMENT
Tools Required:
•
#2 Phillips Screwdriver
•
Jack Stand (or equivalent)
•
Needle Nose Pliers
•
1/2” Combination Wrench
Procedure:
1 . Raise the bed to the highest position .
2 . Position the brake/steer to neutral .
3 . Place a jack stand under the frame where the defective
caster is .
4 . Using a #2 Phillips screwdriver, remove the screw holding
the wheel cover and remove it .
5 . Lower the bed until the caster is six inches off the ground .
6 . Unplug the power cord from the wall outlet .
7 . If the caster is part of the braking mechanism, using
needle nose pliers, remove the rue ring cotter, washer,
and locking axle (A) linking the caster shaft to the locking
lever .
Note
The shaft of a caster that is part of the braking mechanism must be properly oriented before mounting it to the base .
The opposite illustration shows the side of the shaft that should be facing the inside of the bed . It is the side showing
the largest hole below the cam in the neutral position .
8 . Using a 1/2” combination wrench, remove the bolt and two washers (B) holding the caster to the base .
Note
Before tightening the bolt (B), make sure the shaft is completely inserted into the mounting socket .
9 . Reverse the above steps to install the new caster .
10 . Test the bed for proper operation before returning it to service .
52
A
B
C1
C2
D
A
Figure 19
52
Service Information
Summary of Contents for FL28EX
