Stryker CUB FL19H, Maintenance Manual

Page: 41 / 152

A
F Fiig gu urre e 2 26 6 –– H Ha an nd dlle e rre ep plla acce em me en ntt
4. Reverse steps to reinstall.
5. Verify proper operation before you return the product to service.
E En nd drra aiill cce en nttrra all cco ollu um mn n a asssse em mb bllyy rre ep plla acce em me en ntt
W WA AR RN NIIN NG G -- Always have only Stryker service technicians or service personnel trained by Stryker perform this procedure.
Failure to comply can result in serious damage to the bed and or or severe injury to users or patients.
T To oo ollss rre eq qu uiirre ed d::
• #1 Phillips screwdriver
• #2 Phillips screwdriver
• Small screwdriver
• 1/2” socket
• 3/8” combination wrench
• 3/32” Allen wrench
• Cordless drill
• #2 Phillips bit
• Adjustable supports (or equivalent)
P Prro occe ed du urre e::
N No otte e -- Always specify if the product is equipped with the double safety lock when you order a central column assembly.
Proper warning labels are affixed to assemblies with out the double safety lock.
1. Remove the mattress.
2. Raise the rails to the highest position.
3. Apply the brakes.
4. Using a #1 Phillips screwdriver, remove the eight screws (A) that secure the bottom half of the lower plastic cover (B) to
the top half of the lower plastic cover (C) (Figure 27). Save the screws.
5. Insert a small screwdriver between the two halves of the lower plastic cover. Separate the two halves. Use caution to
avoid scratching the covers or damaging the upper cover snap pins.
1900-009-002 Rev AA.6 39 EN