Stryker AIR+ 2863, Maintenance Manual

Page: 14 / 46

P Po ow we err ssu up pp pllyy rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• T20 Torx driver
• #2 Phillips screwdriver
P Prro occe ed du urre e::
1. Unplug the power cord from the wall outlet.
2. Unplug the support surface tubing from the pump.
3. Place the pump face down on a work surface.
4. Using a T20 Torx driver, remove the six screws that secure the back pump housing to the front pump housing. Save the
screws.
5. Using two hands, rotate the pump assembly to the right so the front is to your left.
6. Separate the front and back pump housing. Place the back pump housing down on the work surface.
7. Grasp the hose at the manifold coming from the pump and pull to remove the hose from the manifold.
8. Unplug the power input cable and the power output cable from the power supply.
9. Using one hand to hold the fish paper and a #2 Phillips screwdriver, remove the four Phillips screws and washers that
secure the power supply to the main frame. Save the screws, washers, and fish paper.
10. Remove and discard the power supply.
11. Reverse the steps to reinstall ( Power supply assembly - 2874-007-024 (page 32)).
12. Run and pass the Testing functionality (page 17).
13. Verify proper operation before you return the product to service.
P Po ow we err iin nlle ett rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• T20 Torx driver
• Slotted screwdriver
P Prro occe ed du urre e::
1. Unplug the power cord from the wall outlet.
2. Unplug the support surface tubing from the pump.
3. Place the pump face down on a work surface.
4. Using a T20 Torx driver, remove the six screws that secure the back pump housing to the front pump housing. Save the
screws.
5. Using two hands, rotate the pump assembly to the right so the front is to your left.
6. Separate the front and back pump housing. Place the back pump housing down on the work surface.
7. Unplug the power inlet from the power supply.
8. Using a slotted screwdriver and your finger, push out on the power inlet while you push in on each of the power inlet
locks to loosen the power inlet from the front pump housing. Repeat on the other side to remove.
9. Remove and discard the power inlet.
10. Reverse the steps to reinstall.
11. Run and pass the Testing functionality (page 17).
12. Verify proper operation before you return the product to service.
EN 12 2863-009-002 Rev AA.1