Stryker 6390, Maintenance Manual

Page: 11 / 138

• This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at their expense. In the event of interference, please relocate or
reorient the P
Po ow we err--L LO OA AD D system or interfering product.
• Always relocate or reorient the P Po ow we err-- L LO OA AD D system or interfering product in the event of interference. This device
complies with Part 18 of the FCC Rules.
• Do not use portable RF communications equipment (including peripherals such as antenna cables and external
antennas) no closer than 30 cm (12 in.) to any part of the P Po ow we err--L LO OA AD D system, including cables specified by the
manufacturer. Otherwise, degradation of the performance of this equipment may result.
• The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11
class A). This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area (for which CISPR 11 class B is normally required) is likely to cause harmful interference,
in which case the user will be required to correct the interference at their expense. In the event of interference, please
relocate or reorient the P
Po ow we err--L LO OA AD D system or interfering product.
• Damage may occur if motor armature or stator are bumped around when you replace the motor.
• Do not touch the negative and positive battery terminals together on any metal surface when you replace the battery.
P Piin ncch h p po oiin nttss
F Fiig gu urre e 1 1 –– P Piin ncch h p po oiin nttss
6390-309-002 Rev AB.0 5 EN