BM62
**Assembly of PP35 Power Pack is complete!**
1) Go to instructions for the Attachment (Front or Rear Hitch) that you wish to operate with your Power
Pack.
2) Check with factory for approval and recommendations on using the Power Pack with any Attachments
not listed by our factory for use with the Power Pack!
3) After installaton of your Attachments, return to these instructions for the following “Operation” suggestions
and Safety Tips!
OPERATION
Oil Level:
1. Drive your Crawler to a clear, level work area; preferably a concrete floor. With engine running, operate
your #1920 Valve such that all cylinders controlled by Valve are in the fully closed position...all cylinder
“rods” should be drawn into their respective “cylinders” as far as possible. Shut off engine and engage the
Crawler’s brake! Rock valve handles back and forth to release any pressure through the #616 breather.
2. Using a wrench at it’s base, remove the #616 Breather from the Oil Tank by rotating the total assembly
counter-clockwise. By observation note the oil level inside the Oil Tank. It should be approximately 5” from
the top of Tank. Replenish if necessary with standard AW32 Hydraulic Oil,
3. When satisfied that oil level is correct, replace #616 Breather and tighten clockwise.
NOTE: Breather’s base is plastic, don’t over-tighten!!
