BM60
C) Attach one end of #1731 Hose to
lower
#54 Fitting on Cylinder and the other end to #676
Fitting at
lower right rear
of #1920 Valve. Attach
one end of #1732 Hose to upper Fitting on Cylin-
der and the other end to
upper right rear
#2582
Fitting on Valve... tighten both Hoses!
29) Loop #1737 Hose & #1736 Hose around and
attach #1737 Hose to #676 Fitting at
second from
left lower rear
of #1920 Valve and #1736 Hose to
#2582 Fitting at
upper left rear
of #1920 Valve...
tighten both Hoses. Loop #1733 Hose around and
on left side attach to #676 Fitting at
far left
of
Valve...tighten.
30) Take Hoses #1731, 1732, 1737 & 1736,
gather them together and bind them with a #1860
Plastic Tie [not shown in Photos]. On #1920 Valve
tighten Hoses on all four of the #676 Fittings and
the two #2582 Fittings with an open end wrench!
31) Take the time now to follow the route of the
“pair“ of #1736 & 1737 Hoses and the single
#1733 Hose:
A) Check that they follow a smooth, slack
& obstruction free path and pass properly “over &
under” other hoses and tractor parts as shown in
photos.
B) Check that they are held by the proper
Coated Clips which are oriented in the proper di-
rection.
C) Check that any “slack” in the Hoses ac-
cumulates in front of the #1719 Oil Tank, not along
their path.
D) If you are not going to use the two
“ports” in
center
Valve section, for safety close
them both off with #57 Caps... see Photo below.
32) Bundle and secure with #1860 Plastic Tie
Hoses #1736, 1737 & 1733 at a point about 7” to
the right of the “left edge” of Oil Tank. Using a
#1860 Plastic Tie, bundle Hoses #1736, 1737 &
1733 in front of the 1/4” hole in “right front edge” of
1728A
17
29
1729
1736
1733
1737
1731
1732
57 Cap
1920
Valve
Bank
1860
