5.4 Channel
5.4.1 Auto Tuning (in DVB-T mode only)
First select the Tune Type by pressing
t
u
to select
DVB-T, ATV
or
DVB-T+ATV
(DVB-T to search digital
broadcasts and ATV to search analogue broadcasts). Press
q
to continue. Press
pq
t
u
to highlight
the country that you want to install, then press
ENTER
to start searching.
NOTE:
If you have an active antenna, turn it on in the
Channel
menu and then start
the scan.
5.4.2 Advanced Tuning (in DVB-S mode only)
Access the satellite settings essential for searching programmes through DVB-S sources.
Satellite Dish Settings
A set of satellite dish settings must be configured for each wanted satellite before performing a channel
scan.
Satellite
Select the satellite for this TV.
LNB Type
Make sure the LNB type is corresponding to your dish.
LNB Power
:
Set the power supply for the LNB (usually 13/18 V).
22KHz
Select the 22KHz to set 22K switch to ON/OFF. The Auto mode
(recommended) is used to switch 22KHz on or off depending on the LNB
type.
DISEqC1.0/1.1
Select the DiSEqC mode for the selected LNB.
Highlight
Satellite
and press
ENTER
to access the satellite list and select one. Highlight
LNB Type
and
press
ENTER
to select the LNB type. Make sure the
22KHz, DISEqC1.0/1.1
switch is corresponding to the
selected satellite. After the above steps are finished, press the
BLUE
button to search for channels.
5.4.3 Auto Tuning (in DVB-C mode only)
First select the Scan Type by pressing
t
u
to select
Full
or
Network Scan
.
Selecting
Full
scan the TV will perform a complete scan on all frequencies. Selecting
Network Scan
it is
possible to insert a specific frequency. In this case it will be requested to insert a specific frequency and
Network ID, therefore use
pq
to select the option to change then press
t
u
to insert the frequency
and the Network ID. By selecting auto the TV will search all frequencies.
5.4.4 DTV Manual Tuning (in DVB-T mode only)
Search and store programmes manually.
Select the source type
DVB-T
and search digital programmes manually. In the
Channel
menu, select
DTV
Manual Tuning
and press
ENTER
to access. Press
t
u
to select a
Channel No.
, and then press
ENTER
to
start the search. The search stops when a programme is found and this programme will be stored in the
current channel position. If you want to stop the search, press
MENU
.
5.4.5 DTV Manual Tuning (in DVB- C mode only)
Search and store programmes manually.
10
