6. Position the apex of the canopy
under the center of the top sub-flap
with the bridle exiting to the right
side.
SEE PAGE 23 FOR “CLOSING THE CONTAINER”
R
AM
A
IR
R
ESERVE
Note:
The following canopy packing instructions are only for use with Strong Enterprises Stellar
series reserve canopies. If you are installing another manufacturer’s ram air reserve into the Quasar
II you should refer to that manufacturer’s instructions for canopy packing and go directly to the sec-
tion entitled Folding the Canopy into the Free Bag for further instructions.
A
SSEMBLY
1. Attach the 13’ bridle/free-bag assembly to the pilot chute with a lark’s head knot that passes
through all three of the pilot chute’s dacron line loops.
2. Attach the canopy to the reserve risers using the supplied #5 stainless steel rapid links.
3. Tighten the links securely.
4. Route the control lines down through the rear
slider grommets and their corresponding guide
rings on the risers.
5. Attach the toggles by passing the loop at the
end of the control line up through the toggle’s
grommet, and then around the end of the toggle.
6. Once complete, perform a thorough continuity
check. This may include inflating the canopy to be absolutely sure it is oriented properly.
15
Quasar II Owners Manual Rev.C 11/2000
Strong Enterprises
