Original assembly/operating instructions Gear limit switch Type series 51 • No. 151-00004 H • 01.2018
11
2.9
GCLS safety devices
The GCLS does not have any safety devices of its own.
Except for: certain GCLSs with special housings, which are equipped with a protective cover in the gear wheel
area.
Rotating components of the GCLS that can cause hazards after assembly due to pulling in, must be secured by
the machine operator.
2.10
Safety symbols/pictograms on the GCLS
The GCLS is equipped with the following safety symbols/pictograms.
2.11
Wear personal protective equipment
Personal protective equipment must be worn for all work to be carried out, see section 2.8.3. The wearing of
personal protective equipment must be monitored by the operator. It may be the case that the operator has to
meet additional measures.
2.12
Basic responsibilities of the operator and personnel
The following fundamental responsibilities of the operator and personnel must always be observed when handling
the GCLS.
•
After assembling the GCLS, a risk analysis of the workplace must be carried out by the operator on the
complete machine. In addition to the documentation, operating instructions must be created.
•
In addition to the documentation, observe and instruct adherence to general legal and other binding
regulations on accident prevention and protection of the environment. Such obligations can also, for e.g.,
affect the handling of hazardous substances or the provision/wearing of personal protective equipment.
•
Supplement the documentation with your own instructions, including supervisory and reporting obligations for
specific operational matters, e.g., with regards to the organisation of work, work sequences and appointed
personnel.
•
Never make changes, additions or conversions to the GCLS without the manufacturer's approval. If changes
are made to the GCLS that affect safety, they must be reported to Stromag GmbH immediately.
•
Only use genuine spare parts.
2.13
Safe handling of rotating components
The following safety guidelines must always be observed when handling rotating components.
•
Before commencing work, shut down the machine and secure it from switching back on.
•
Never operate the machine without separating protective equipment.
•
After inspection and maintenance work, remount the separating protective equipment.
2.14
Safe handling with hot surfaces
The following safety guidelines must always be observed when dealing with hot surfaces:
•
Before commencing any work, first allow the hot surfaces to cool down.
Prohibition signs
Explanation
Observe the instructions in the documentation.
