26
BA_327D_A2_200715_en.doc
5
Operating the sewing machine
C A U T I O N ! Danger of injury!
Take sufficient
care
during sewing and observe the sewing area!
Otherwise there is a
danger of injury
from crushing and needle
punctures.
For machines with 2 pedals: push down the left pedal fully increases the top feed
length (multi-width take-up). With this configuration, motor control is taken over by
the right pedal.
To lift the machine, a pneumatic lifting system can be supplied instead of the knee
lever.
When releasing the pedal to switch on the motor, the machine moves to its position
and pneumatic lifting takes place.
Pressing the pedal forwards closes the lifting and the machine starts to sew.
Fig. 14
5.1
Switch-on
Switch on the main switch on the right underneath the table plate.
With pneumatic lifting, connect the service unit to the compressed air network
(10 bar) or connect the compressor and regulate to 5 – 6 bar.
The lifting is now opened and the sewing machine is ready for operation.
Summary of Contents for 327D
Page 5: ...1 BA_327D_A2_200715_en doc...
Page 6: ...2 BA_327D_A2_200715_en doc...
