STRIDE SE-MC2U-SC, User Manual

Page: 164 / 230

Stride Industrial Ethernet Switches User Manual 2nd Ed. Rev. B
Appendix A - Troubleshooting
Troubleshooting VLANs
The most common VLAN is the Tag-based VLAN. A typical tag-based VLAN
implementation requires configuring the VLANs on the VLAN Settings page AND
configuring the ports for each VLAN on the VLAN Port Settings page:
For a Tag-based VLAN (commonly referred to as an 802.1q or a Dot 1q VLAN)
On the VLAN Settings page:
Set VLAN mode to Standard
Add the VLANs you wish to have configured, leaving the Type selection “Tag-based.” In
our example, we are creating two VLANs called VLAN 20 and VLAN 30. The names are for
your convenience. The IDs on this page will match the PVIDs we configure on the VLAN
Port Settings page and will determine VLAN participation.
We will configure port 2 as a Network (Trunking) port on the VLAN Port Settings page, so
here on the VLAN Settings page we include Port 2 in both of our VLANs.
For security, we have chosen to reserve Port 1 as the only port through which the Switch
Configuration utility can be accessed; we have eliminated all other ports from the
Management VLAN and we have not included port 1 in the other VLANs.
A-6