page 1
STRESSVEST INC.
1080 Kingsbury Avenue • Winnipeg, Manitoba, Canada R2P 1W5
Toll Free: 1-866-353-5055 • Ph: (204) 336-0011 • Fax: (204) 586-2049 • [email protected]
Operating Instruction:
QUICK SETUP GUIDE
PREPARING THE STRESSX™ PRO BELT & THE
STRESSVEST® TRANSMITTER
Each StressVest® comes with a Vest Receiver (front & back), Transmitter, and
StressX™ PRO Belt. In order for the StressVest® to function, the Transmitter (on
back of StressVest®) needs to be synced (connected) with the StressX™ PRO.
Once synced, when the Vest Receiver is hit with the laser pulse the Transmitter will
send a wireless signal to the StressX™ Belt which will deliver the pain penalty or
vibration.
SYNCING THE STRESSX™ PRO BELT & THE STRESSVEST® TRANSMITTER
1. Turn ON the StressX™ PRO. Press the Sync Button once on the StressX™
PRO. It should be flashing red indicating that the StressX™ is in sync mode.
The LED Display should be blank. If it is, then the StressX™ is ready for Syncing.
2. Turn ON the StressVest® Transmitter and press the Sync Button once. The Sync Status Light Indicator should be
flashing indicating that it is not currently synced to a StressX™ PRO. If it is, the StressVest® Transmitter is ready for
Syncing.
1. Press the Sync Button once on the StressX™. It should be flashing red
indicating that the StressX™ is in sync mode and ready to sync. The LED
Display should be blank.
2. Press the Sync Button once on the StressVest® Transmitter. The Sync
Status Light Indicator should be flashing red indicating that the StressVest®
Transmitter is in sync mode and ready to sync.
3. Hold the StressVest® Transmitter with Sync Window towards the Sync
Window of the StressX™. Once synced the StressX™ Sync Button will
stop flashing and turn solid red and the StressVest® Transmitter Sync Status Light Indicator will also turn solid red. To
verify that they are now both synced, press the Sync Button on the StressX™ you should now see an “A” in the LED
Display.
Unsyncing the StressX™ Belt
- If the StressX™ PRO LED Display is showing an “A”, that means the StressX™ PRO is currently
synced to a StressVest® Transmitter and it must be Unsynced prior to syncing to a new StressVest® Transmitter. To Unsync, press
and hold the Sync Button down for seven seconds until the LED Display goes blank. The StressX™ PRO belt is now ready for
syncing to a new StressVest® Transmitter.
Unsyncing the StressVest® Transmitter
- If the Sync Status Light Indicator is solid red, then the StressVest® Transmitter is
currently synced and it must be Unsynced prior to syncing to a new StressX™ PRO. To Unsync, press and hold the Sync Button
down for seven seconds until the Sync Status Indicator Light begins to flash red. The StressVest® Transmitter is now ready for
Syncing to a new StressX™ PRO Belt.
Note:
StressX™ and StressVest® Transmitter will remain synced even when you turn them off. However, once powered up again it
is recommended that you Unsync and Re-Sync them to ensure you have the correct pairing of units.
StressX™ PRO Belt
StressVest® Transmitter
