52
17.7.2.4 Parameters 50 to 59
– Room Sensor
No.
Operating line
Settings
50*
Room temperature
51*
Room temperature min
52*
Room temperature max
54*
Readjustment room sen-
sor (Temperature).
55*
Room humidity
59*
Readjustment room sensor (Humidity).
* Operating lines only available on QAA74. QAA74 must be configured as room unit.
The above
setting will only be required if the user interface is addressed as a “room unit.”
17.7.2.5 Parameter 70
– Software Version
Shows the present version of the user interface.
17.8
Operate Service / Setting Pages
The following is displayed on the service/setting pages ( ):
1.
Regional Settings : Settings relating to the room / operator unit.
2.
Special Operation : Operating special functions.
3.
Settings : Settings relating to the plant.
4.
Expert: Login to expert view.
17.8.1
R
EGIONAL
S
ETTINGS
The parameters within these settings are included within the
commissioning wizard except for start and ends of daylight saving
time. The settings are:
•
Time.
•
Date.
•
Daylight saving time start and end.
•
Language.
Proceed as follows to change regional settings:
1.
Turn the control knob and select the Regional settings.
2.
Press the control knob.
'Regional settings' opens. The title of the regional settings page is preselected.
3.
Turn the control knob to go to an adjustable value.
4.
Press the control knob to access the setting.
5.
Turn the control knob and enter the value.
6.
Press the control knob to confirm the settings. The value is once again
preselected.
7.
Go to the title for additional regional settings or exit regional settings with "Back".
Summary of Contents for S-ASX 30
Page 2: ...2 ...
Page 24: ...24 10 CORRECTIVE FACTORS 10 1 Heating Performances ...
