OPERATING INSTRUCTIONS FOR THE STREAMLIGHT
®
LI-ION BATTERY BANK CHARGER
SAFETY
SAVE THESE INSTRUCTIONS.
This document contains important safety, operating and maintenance
information for your charger.
CAUTION:
To reduce risk of fire, electrical shock, or personal injury, do not attempt to use this charger
to recharge other manufacturer’s batteries.
Do not use a damaged charger.
Do not place any metal objects onto the charging terminals located in the charger.
Do not disassemble or try to repair the charger. Return it to a qualified service facility or the factory.
Use only Streamlight
®
SL-B26™ protected Li-Ion USB rechargeable battery pack P/N 22101 or 220115.
Recycle worn out or damaged battery packs properly.
CAUTION:
To reduce risk of fire, electrical shock, or personal injury, handle the battery pack carefully
and never allow it to short circuit. Do not incinerate the battery pack as it may explode in a fire.
CHARGER
The Li-Ion battery bank charger is available with the following power supplies: 120VAC power supply,
International Power supply or 12 VDC “flying lead cord” for vehicle installations.
Charge cord installation:
1. Insert the 2.5mm barrel connector from the cord into the power jack on the back of the charger.
2. Route the charge cord under the retaining tabs with the end of the cord exiting through either the
bottom or side slot in the charger.
Connect the AC power supply or International power supply to a wall outlet for wall mounted operation or
connect the barrel plug with flying leads for vehicle mounted operation (see
INSTALLATION IN
VEHICLES
below).
