3. Installation
3
Installation
This section of the user manual will cover the installation of your SAS220 device, including mounting
and connection.
3.1
Rack mount
In line with the other Streamit professional audio devices, the SAS220 design enables you to easily
mount it in a conventional 19 inch (1 inch = 2.54 cm) racks. For rack mounting, the rack-mounting kit
is required.
Fig. 4: Streamit rack mounting kit
This kit can be ordered from Streamit or official Streamit dealers and contains 5 mounting plates in total
as shown in the figure above. Using a combination of these plates, it is possible to mount either one or
two devices in a 19 inch rack.
3.1.1
Mounting a single SAS220 device in a 19 inch rack
To mount a single SAS220 in an 19 inch rack, you make use of the large side mounting plate and one of
the small side mounting plates. At each side of the device, there are two screws and two small slot-like
openings. Start with one side of your device and remove the Phillips-head screws using an appropriate
screwdriver. Place the large side mounting plate as shown in figure below. You will see that the holes
of the mount plate will match those of the device. Carefully fasten the screws back on to connect the
device to the mounting plate. The same is done for the other side, but in this case one of the small side
mounting plates is used.
Fig. 5: One SAS220 in rack mount configuration
Version 1.3
28/10/2015
6 of 21
