Service and maintenance
Sherpa 120, 140 | 06.19
191
9.25.2 Adjust scraper bar
Operative staff:
•
Operator
NOTE
The distance between the scraper bar and the ground should
be approx. 5 mm.
1. Lift the pick-up arm.
2. Open the milling drum guard or the cutting unit.
3. Secure the pick-up arm against accidental lowering by
means of appropriate support trestles.
4. Secure the machine against accidental starting and
rolling.
5. Loosen all nuts of the screws (1).
6. Move the scraper bar (2).
7. Turn the scraper bar over if it is only worn on one side.
8. Adjust the distance of the scraper bar to the ground.
–
Reduce distance:
Move the scraper bar to the front.
–
Increase distance:
Move the scraper bar to the rear.
9. Tighten all nuts of the screws (1).
Fig. 155
Summary of Contents for Sherpa 120
Page 2: ......