Service and maintenance
Sherpa 120, 140 | 06.19
189
9.24 Tighten and adjust side discharge conveyor
Operative staff:
•
Qualified staff
1. Secure the machine against accidental starting and
rolling.
2. Unscrew the counter nut (1) at the right-hand and left-
hand radial insert ball bearing (5).
3. Equally turn the two clamping nuts (3),
– The conveyor belt must sag by approx. 10 to 15 mm
in its centre.
– The distance A between the flat profile (2) and the
nut (4) must be equal on both sides of the conveyor
belt.
4. Carry out a test run.
– Check whether the conveyor belt has an equal
distance to the frame at the return rollers on both
sides.
– Readjust the distance by turning the clamping nuts
(3) if necessary.
5. Tighten the counter nut (1) at the right-hand and left-hand
radial insert ball bearing (5).
Fig. 153
Summary of Contents for Sherpa 120
Page 2: ......
