Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual, Page: 114 / 327

Commissioning
Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18 114
5.12.2 Connect hydraulic hose pipes
Check the compatibility of the hydraulic oils before connecting the
machine to the hydraulic system of your tractor.
•
Do not mix mineral oils with bio oils!
•
Observe the maximum admissible pressure of the hydraulic oil
of 200 bar.
•
Only couple clean hydraulic plugs.
•
Insert the hydraulic plug(s) into the hydraulic sleeves until the
hydraulic plug(s) noticeably lock(s)..
•
Check the coupling spots of the hydraulic hose pipes for
correct and tight seat.
•
Depressurise hydraulic system.
•
Check the assignment of the hydraulic hose pipes at the
control block of the machine if the coloured markings (dust
caps) are missing:
•
P=Pressure line
•
T (R;S)=Return line
5.12.2.1 Open hydraulic system
1.

Always swivel the respective operating
element at the control device on the tractor
to floating position.
2.

Turn the tractor engine off.
3.

Unscrew the load-sensing screw (1) at the
electro-hydraulic control block as far as it
will go.
4.

Connect the pressure line (flow line) to a
single-acting or double-acting control
device of the tractor.
5. Connect the tank line (return line) to a
depressurised return line of the tractor.
Fig. 60