Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual

Page: 109 / 327

Commissioning
109 Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18
5.10 Set cutting length
The number of cutting knives mounted in the cutting unit determines the cutting length of the loaded
material. 44 cutting knives at one level ensure a cutting length of 35 mm. For information about
removal and installation of cutting knives, see chapter "Remove and install cutting knives".
5.11 Mount control set on the tractor
5.11.1 Mount ISOBUS control set on the tractor
•
Do not draw the current from the light socket.
•
Retrofit the 3-pole socket if your tractor is not equipped with a
3-pole socket. An appropriate retrofit kit is available.
•
A constant power supply of 12 V is required. Protect the 3-pole
socket by a fuse of at least 25 A.
•
The feed line of the 3-pole socket must have a minimum cable
cross section of 4 mm
2 .
•
There are tractor models where the standard socket in the
tractor cabin delivers inadequate power for the ISOBUS control
set. In this case, have an authorised workshop install a
separate battery cable (BSL no. 87008925).
1. Fix the control set (1) in the cabin within
view and reach to the right of the driver
seat.
2. Connect the signal plug (2) of the control
set with the signal socket (3) of the mobile
cable harness or with the signal socket of
the tractor (if available).
3. Plug the 3-pole plug (4) (DIN 9680) of the
mobile cable harness into the 3-pole
socket of the tractor.
(Pole 15/30 = Plus; Pole 31 = Minus)
This is not necessary if the tractor is
equipped with an ISOBUS cable harness.
Fig. 58
4. Depending on the equipment, plug:
•
the ISO socket (5) of the mobile cable harness into the ISO plug of the control unit on the
machine.
•
the ISO plug of the control unit into the ISO socket of the tractor.
If available, always use the ISOBUS socket on the tractor!