Stratasys uPrint, Service Manual, Page: 89 / 383

4-42
Circuit Breaker
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
• Phillips screwdriver
Removing the circuit breaker
1.
Open the electronics bay. See Opening the electronics bay on page 4-15.
2.
Touch the metal plate of the electronics bay cover to discharge any static electricity.
3.
Remove the Load and CB1 spade connectors from the circuit breaker by pulling up on
the connectors. See Figure 4-70.
Figure 4-70: Load and CB1 spade connector locations
4.
Remove the CB1 Line and CB2 spade connectors from the circuit breaker by pulling up
on the connectors. See Figure 4-71.
Figure 4-71: CB1 Line and CB2 spade connector locations
5.
Squeeze the tabs on the circuit breaker and push through the electronics bay panel. See
Figure 4-72.
CB1
Load
CB1 Line
CB2