Stratasys uPrint, Service Manual, Page: 87 / 383

4-40
Line Filter
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
• Phillips screwdriver
Hardware
• 6-32 x
1
⁄
4
” Phillips pan head screws (x3)
Removing the line filter
1.
Open the electronics bay. See Opening the electronics bay on page 4-15.
2.
Touch the metal plate of the electronics bay cover to discharge any static electricity.
3.
Remove L1-1 and N1-1 spade connectors from the right side of the board by pulling back
on the connector. See Figure 4-67.
Figure 4-67: L1-1 and N1-1 spade connector locations
4.
Remove L2-1 and N2-1 Spade connectors from the left side of the board by pulling up on
the connector. See Figure 4-68.
Figure 4-68: L2-1 and N2-1 Spade connector locations
Disconnect the N1-1
spade connector
Disconnect the L1-1
spade connector
Disconnect the L2-1
spade connector
Disconnect the N2-1
spade connector