Stratasys uPrint, Service Manual, Page: 378 / 383

uPrint/uPrint SE Service Manual 9-5
Controller Board Checklist
Use this checklist when replacing the Controller Board. Due to possible software version
conflicts, additional steps must be taken after installing a Controller Board - the complete (X,
Y, Z) homing process must be run before building a part. Failure to perform these steps may
result in Z build location and/or cartridge read issues. This problem will be corrected in the
next board firmware release.
Procedure

Unload material.

Power down the system.

Replace the controller board.

Power up the system

When prompted, download the system software.

Enter Head Maintenance. This will cause the system to run the complete homing process.

Exit Head Maintenance

Load material.

Run a small test part to ensure part quality is acceptable and that the XY table is functioning
correctly.

Discuss with the customer any questions or issues they may have.

Pack the old controller board into the shipping box along with the RMA documentation and
ship back to Stratasys.