Stratasys uPrint, Service Manual, Page: 376 / 383

uPrint/uPrint SE Service Manual 9-3
Toggle Head Assembly Installation Checklist
If you have any questions before or during installation, do not hesitate to call your Customer
Support provider.

Replace the Toggle Head Assembly.

Verify that all electrical leads are connected correctly.

Clean and vacuum the system.

Power system up and verify that head reaches temperature and the system homes correctly.

Using DataStat or MaracaEX enter the Z Tip to Tip value that came with the head and cycle
power.

Load material.

Perform the Z Calibration and XY Offset Calibration.

Run a part to ensure part quality is acceptable and that head is functioning correctly.

Unload material.

Remove the system CD from the electronics bay and discard.

Using MaracaEX select “Get” to send the .cal file from the system to a new blank CD. Place
the new CD in the electronics bay and secure the rear door.

Load material.

Discuss with the customer any questions or issues they may have.

Pack the old Toggle Head Assembly into the shipping box along with the RMA
documentation and ship back to Stratasys.