Stratasys uPrint, Service Manual, Page: 352 / 383

uPrint/uPrint SE Service Manual 7-9
2000 Hour maintenance
Tip replacement and calibration
A Preventive Maintenance Alert will be displayed after 2000 hours of run time informing
you that tips need to be replaced and calibrated. See
Figure 7-408.
Figure 7-408: Preventive Maintenance Alert
Removing tips
1.
You will need to make sure the printer is powered ON before replacing the extrusion
tips.
2.
From the display panel press
Maintenance.
3.
Press
Machine.
4.
Press
Tip
.
5.
Press
Replace
.
6.
The printer will display
Material Unload - Unloading Model.
7.
When finished unloading, the display will prompt to remove the material carriers. Push
the material carriers in and release to unlatch.
8.
You can now open the printer door and replace the tips - or you can
Cancel
the tip
replacement procedure.
9.
Remove plastic head cover by squeezing raised pads on sides of cover. See Figure 7-409.
Note: Tips can also be damaged by improper care while performing maintenance
in the area around the tips.
Note: CatalystEX displays the tip time (hrs) - from the Printer Services Tab -
Printer Info button (Tip time will reset to zero after replacement).