Stratasys uPrint, Service Manual, Page: 344 / 383

uPrint/uPrint SE Service Manual 7-1
Preventive Maintenance
Startup kit tools_______________________________________________________ 4-2
Preventive Maintenance _____________________________________________ 4-2
Daily ______________________________________________________________ 4-2
Empty the purge bucket _______________________________________ 4-2
Inspect the tip wipe assembly __________________________________ 4-2
Inspect the tip shields __________________________________________ 4-2
Remove debris buildup_________________________________________ 4-2
Vacuum build chamber________________________________________ 4-2
Clean door ____________________________________________________ 4-2
500 Hour maintenance ____________________________________________ 4-3
Tip wipe assembly______________________________________________ 4-3
Tip shield replacement _________________________________________ 4-5
Remove debris from the Filament Present switch _________________ 4-8
2000 Hour maintenance ___________________________________________ 4-9
Removing tips _________________________________________________ 4-9
Installing tips __________________________________________________ 4-11
Tip calibration ________________________________________________ 4-13
Chamber light bar replacement _______________________________ 4-15