Stratasys uPrint, Service Manual, Page: 322 / 383

uPrint/uPrint SE Service Manual 6-55
Rough surface quality
Characteristics: Sides of part are rough or over filled, with little or no part shift.
73.
Corrective actions
1.
STL wall thickness is too thin. Verify proper wall thickness.
2.
Reprocess the part using the latest version of CatalystEX software and check STL report
for errors.
3.
Check for STL errors in CAD software.
4.
Replace the tip shrouds.
5.
Loose tips screws, tighten the screws.
6.
Replace the tips.
7.
Check X/Y guide rods for loose hardware. Replace XY table as needed.