Stratasys uPrint, Service Manual, Page: 320 / 383

uPrint/uPrint SE Service Manual 6-53
Part fell over
Characteristics: A part falls over and separates at the support base or substrate. Material will
continue to extrude causing strands of material to build up in the envelope.
71.
Corrective actions
1.
Substrate has been re-used or is defective. Replace the substrate.
2.
Check for material build up on tips, brush and flicker. Remove excess material.
3.
Verify brush/flicker height. Adjust if required.
4.
The part does not have sufficient support material. Reprocess the part using basic or
surround support in CatalystEX.
5.
The base support layer is separating from the substrate. Run Z calibration.
6.
Model material is separating from the support base top layer. Run Z calibration.
7.
Z stage may not be moving properly. Check for obstructions.