Stratasys uPrint, Service Manual, Page: 313 / 383

6-46
Part Quality Troubleshooting
Embedded support strands in model
Characteristics: Strands of support material embedded in model.
63.
Corrective actions
1.
Change the part orientation. Rotate part 90 degrees - see example above.
2.
Build the part using the “Basic” support option.
3.
Material is built-up on the shields. Using a brush to remove the excess material.
4.
Replace tip shields.
5.
Check brush flicker assembly for damage or wear. If worn or damaged, replace brush
flicker assembly.
6.
Tip(s) are loose, check if tip screws are loose. Tighten tip screws.
7.
Replace support material.
Example of embedded support
Problem corrected after re-orientation